Saturday, July 13, 2013

S&W Shield Defensive Ammo Test

There are lots of debates out there about what ammo to use in the new breed of short barreled 9mm guns.  So, I brought a few loads to test from my S&W Shield 9mm.  Here's what I found:



Test conditions: 
-S&W Shield with a 3.1'' barrel
-Test rounds fired from 10 feet 
-"FBI spec" (Their term, not mine...) Clear Ballistics gel block
 

Results:
Remington UMC 115gr JHP
-1065 FPS/292 FT/LBS energy
-18.5'' of penetration


Winchester Ranger 115gr JHP
-989 FPS/250 FT/LBS energy
-16'' of penetration

Federal HST 124gr JHP
-990 FPS/270 FT/LBS energy
-13.5'' penetration


Federal HST 124gr JHP +p
-1071 FPS/316 FT/LBS energy
-12'' of penetration


Speer Gold Dot 124gr +p
-1176 FPS/382 FT/LBS energy
-15.5'' penetration


Brown Bear 115gr FMJ (since some folks say you need FMJ out of these guns for 'adequate' penetration)
-1046 FPS/279 FT/LBS energy
-26'' of penetration

To see the test, the results, and the actual expansion of the round when I pulled them out of the gel block check out the video test below:






Here's the video showing the test, the permanent cavity, both shots into the gel, and a discussion of the results:

1 comment:

  1. Nice to read this article will be very helpful in the future, share more info with us. Good job!
    glock-doc.com

    ReplyDelete